Male On Both Ends Shut Off Cock

Model:XJ56165

Send Inquiry

Product Introduction

Part#	Male x Male	Ind#	A	B	Hex	PARKER	MAF	Tectran	Fleet Pride	Tramec Sloan
XJ56165	1/8	76-P	2.15	1.80	0.69	V401P-2-2	46165			SV401-2
XJ56166	1/4	77-P	2.22	1.84	0.70	V401P-4-4	46166	2122-B	VHP411-4	SV401-4
XJ56166T	1/4		2.23	2.00	0.68		46166T
XJ56167	3/8	78-P	2.43	2.24	0.82		46167			SV401-6

Male Pipe x Male Pipe is a brass globe valve connector in the Shut Off Cocks series, with male Pipe Thread on both ends, which controls fluid flow through an internal valve. It is designed to connect two internally threaded pipelines or equipment, suitable for scenarios that require quick opening and closing of fluids and maintaining pipeline coaxiality, such as water supply systems, industrial hydraulic pipelines, and gas equipment.

Technical parameters (typical values)：

Parameter	Value/Range
Maximum working pressure	Static pressure of 25 bar (water/oil)/16 bar (gas).
Temperature	-20 ° C to+120 ° C (brass body)/Temperature resistant sealing material (such as EPDM rubber:- 40 ° C to+150 ° C.
Valve Type	Ball valve (quick opening and closing) or gate valve (flow regulation)
Traffic characteristics	Full bore design (ball valve) or linear flow control (gate valve)

Matters needing attention：

Thread matching:

Strictly distinguish between BSPP (parallel thread), NPT (tapered thread), and metric thread. Mixing them can lead to leakage or damage.

Selection of sealing material:

Water/Air: PTFE tape (low cost, easy to operate).

Oil/high-pressure system: Anaerobic adhesive (strong sealing and impact resistance).

Valve operation:

The ball valve should be fully opened/closed to avoid accelerating the wear of the sealing ring in a semi open state.

When adjusting the flow rate with a gate valve, it is necessary to operate slowly to prevent sudden pressure changes.

Differences from similar products:

Comparison items	Male Pipe x Male Pipe	Female x Female	Compression x Male
Interface Type	External thread x External thread	Internal thread x Internal thread	Compression type x external thread
Adaptation scenario	Connect the same shaped interface (pipeline+pipeline)	Connect the same shaped interface (pipeline+pipeline)	Connect flexible pipes and threaded equipment
Installation complexity	Medium (requires handling of double threaded seals)	Medium (requires double threaded seal)	Low (only requires compression installation)
Maintain convenience	Disassemble after emptying the system	Disassemble after emptying the system	Repair without emptying

Hot Tags: male on both ends shut off cock, China male on both ends shut off cock manufacturers, suppliers, factory, Union Tee PTCR Fitting, Compression Fitting Shut Off, Female 37 JIC Flare Swivel, Brass Shut Off Cock Male, High Pressure Long Street Ells, Shut Off Cock Female Pipe

Compression On Both Ends Shut Off Cock

No Information