Flareless Bulkhead Union

When it is necessary to connect the pipes on both sides through the panel, the working process of the brass mesh Bulkhead Union is as follows:
Fix through the panel: Pass the accessories through the preset opening of the panel, and tighten the nuts on both sides to clamp the panel. At this time, the panel seal is compressed to block the leakage channel between the panel and the accessories;
Pipe connection: The pipe on the inner side of the panel is screwed into the left internal thread, and the pipe on the outer side is screwed into the right thread, and the mechanical connection is achieved through the thread bite;
Double sealing: When the pipes are connected, the sealing ring at the interface is squeezed and deformed by the thread to achieve the sealing of the pipe interface; at the same time, the panel seal is continuously compressed to prevent the medium from leaking from the panel opening;
Easy maintenance: If one side of the pipe needs to be repaired, only the connection end on the corresponding side needs to be loosened (manual operation using the mesh), and there is no need to remove the plate fixing structure, which greatly reduces maintenance time (saving 80% of labor hours compared to traditional welded plate joints).

Anti-slip and efficient, the friction coefficient of the textured surface is 1.5 times that of the smooth surface. No wrench is required for manual tightening. It is especially suitable for scenes with narrow space on both sides of the panel (such as in cabinets and equipment chassis), and the installation efficiency is increased by 40%.

Hot Tags: flareless bulkhead union, China flareless bulkhead union manufacturers, suppliers, factory, flareless 90 degree fitting, flareless fluid connector, flareless inline adapter, flareless metric fitting, flareless tee nut, flareless tube stop